Free NACE-CIP1-001 Exam Questions - Easiest Way for Success

Prepare for the AMPP NACE-CIP1-001 exam questions with our authentic preparation materials, including free NACE-CIP1-001 practice exam questions and answers. TheExamsLab provides all the support you need to succeed in the Coating Inspector Program (CIP) Level 1 NACE-CIP1-001 exam. This dedication to student success is why we have the most satisfied NACE-CIP1-001 certification exam candidates worldwide.

Page: 1 / 20

Total 99 Questions | Updated On: Sep 13, 2024

Add To Cart

Question 1

When working as a NACE Inspector in a situation where there is a difference of opinion, the Inspector needs to:

A : Go with the majority opinion

B : Never change his/her mind

C : Achieve consensus through negotiation

D : Call the supervisor

Answer: B

Question 2

When using a sling physchrometer a very large difference between the wet and dry bulb readings indicates:

A : High Relative Humidity

B : Low Relative Humidity

C : High Surface Temperature

D : Low Surface Temperature

Answer: B

Question 3

Whenever dissimilar metals must join, the most common practice is to

A : provide cathodic protection to prevent corrosion

B : provide anodic protection to prevent corrosion

C : coate all connected dissimilar metals

D : avoid coating all connected dissimilar metals

Answer: A

Question 4

Upon arrival of coating materials, the inspector should

A : review coating contractor’s plans for storage of coating materials and confirm they meet national, local and owners’ fire and environmental regulation

B : observe and document the amount of material and batch numbers

C : observe aryl document that the applicator WFT at regular intervals during application

D : observe and document time frame and environmental conditions between each coat

Answer: B

Question 5

A single application coating film has measured dry film thickness (DFT) between 4 and 5 mils (between 100 and 125 microns). The volume solids of the coating immediately before application were 67%. What wet film thickness (WFT) was applied?

A : 5 to 6 mils (125 to 150 microns)

B : 10 to 12 mils (250 to 300 microns)

C : 8 to 10 mils (200 to 250 mils)

D : 6 to 7 mils (150 to 175 microns)

Answer: D

Page: 1 / 20

Total 99 Questions | Updated On: Sep 13, 2024

Add To Cart