Free Practice Juniper JN0-664 Exam Questions 2025

Stay ahead with 100% Free Service Provider - Professional (JNCIP-SP) JN0-664 Dumps Practice Questions

Page: 1 / 19

Total 91 Questions | Updated On: Feb 19, 2025

Add To Cart

Question 1

You are asked to protect your company's customers from amplification attacks. In this scenario, what is Juniper's recommended protection method?

A : ASN prepending

B : BGP FlowSpec

C : destination-based Remote Triggered Black Hole

D : unicast Reverse Path Forwarding

Answer: C

Question 2

Exhibit

Referring to the exhibit, what do the brackets [ ] in the AS path identify?

A : They identify the local AS number associated with the AS path if configured on the router, or if AS path prepending is configured

B : They identify an AS set, which are groups of AS numbers in which the order does not matter

C : They identify that the autonomous system number is incomplete and awaiting more information from the BGP protocol.

D : They identify that a BGP confederation is being used to ensure that there are no routing loops.

Answer: B

Question 3

Click the Exhibit button.

You are troubleshooting an issue for a customer site that uses 10.10.0.0/24 in AS 65224, but you see another AS in the AS path.

Referring to the exhibit, what is the cause of the problem?

A : AS 65000 is pre-pending AS 65137 to route advertisements.

B : The local AS is in the process of withdrawing the route from AS 65137.

C : AS 65137 is advertising the 10.10.0.0/24 prefix.

D : The local AS is receiving two equal cost routes to 10.10.0.0/24.

Answer: C

Question 4

Which two statements are correct about VPLS tunnels? (Choose two.)

A : LDP-signaled VPLS tunnels only support control bit 0.

B : LDP-signaled VPLS tunnels use auto-discovery to provision sites

C : BGP-signaled VPLS tunnels can use either RSVP or LDP between the PE routers.

D : BGP-signaled VPLS tunnels require manual provisioning of sites.

Answer: B,C

Question 5

You are configuring a BGP signaled Layer 2 VPN across your MPLS enabled core network. Your PE-2 device connects to two sites within the s VPN In this scenario, which statement is correct?

A : By default on PE-2, the site's local ID is automatically assigned a value of 0 and must be configured to match the total number of attached sites.

B : You must create a unique Layer 2 VPN routing instance for each site on the PE-2 device.

C : You must use separate physical interfaces to connect PE-2 to each site.

D : By default on PE-2, the remote site IDs are automatically assigned based on the order that you add the interfaces to the site configuration.

Answer: D

Page: 1 / 19

Total 91 Questions | Updated On: Feb 19, 2025

Add To Cart