Free Practice Juniper JN0-363 Exam Questions 2025

Stay ahead with 100% Free Service Provider Routing and Switching Specialist (JNCIS-SP) JN0-363 Dumps Practice Questions

Page: 1 / 20

Total 100 Questions | Updated On: Feb 18, 2025

Add To Cart

Question 1

You are adding an IPv6 configuration to an Interface on a Junos device.

In this scenario, which statement is correct?

A : The link local address must be manually configured within the fdO0::/8 prefix range.

B : The link local address must be manually configured within the fe80::/10 prefix range.

C : The link local address is automatically created using the MAC address within the fe80::'l0 prefix range.

D : The link local address is automatically created using the MAC address within the fd00::/8 prefix range.

Answer: D

Question 2

You are deploying an MC-LAG connection at the edge of your network to a new customer. This solution must ensure that traffic uses all available links when forwarding traffic between the two networks.In this scenario, which two statements are correct? (Choose two.)

A : Transit traffic sent between the two PE devices will use the ICL interface.

B : You must use active/active mode when defining the MC-LAG bundle.

C : You must use active/standby mode when defining the MC-LAG bundle.

D : Transit traffic sent between the two PE devices will use the bundle’s member interfaces.

Answer: A,B

Question 3

Click the Exhibit button.

Referring to the exhibit, which two statements are correct? (Choose two.)

A : Traffic ingressing ge-1/0/0 that is tagged with VLAN 200 will be dropped.

B : Traffic ingressing ge-1/0/0 that is tagged with VLAN 100 will be dropped.

C : Traffic ingressing ge-1/0/0 that is tagged with VLAN 100 will egress ge-1/0/4 with an outer VLAN tag of 200.

D : Traffic ingressing ge-1/0/0 that is tagged with VLAN 200 will egress ge-1/0/4 with an outer VLAN tag of 200

Answer: A,C

Question 4

Exhibit.

Referring to the exhibit, you have configured an aggregate route that represents the 172.21.0.0/24,

172.21.1.0/24, and 172.21.2.0/24 networks. However, when you view the routing table, your new route

hidden.

Which action would you perform to determine the problem?

A : Verify that you have active contributing routes on the device.

B : Verify that you have configured a policy on the device to accept aggregate routes.

C : Verify that you have defined a metric value for the aggregate route.

D : Verify that you have set the preference to a lower default value.

Answer: D

Question 5

Exhibit

You are asked to configure OSPF between routers R1 and R2 using IPv6 addresses.

Which two tasks will accomplish your objective? (Choose two.)

A : Issue the sec protocols ospf area 0.0.0.0 interface ge-0/0/1.0 command.

B : Under the [edit routing-options] hierarchy, configure a 32-bit router ID.

C : issue the set protocols ospf3 area 0.0.0.0 interface ge-0/0/1.0 command.

D : Under the [edit routing-options] hierarchy, configure a 128-bit router ID.

Answer: A,D

Page: 1 / 20

Total 100 Questions | Updated On: Feb 18, 2025

Add To Cart