Free H31-341_V2.5 Practice Exam Questions Online

Why Huawei H31-341_V2.5 Practice Exam Questions?

Ready to level up your Huawei H31-341_V2.5 exam study? Just TheExamsLab H31-341_V2.5 practice tests free.

H31-341_V2.5 exam questions are expertly crafted practice tests designed to simulate the real Huawei certification exam environment and help you assess your knowledge and figure out where you are lacking. From our free HCIP-Transmission V2.5 H31-341_V2.5 practice exam, you will feel secure in passing any question type or time limit. TheExamsLab offers the H31-341_V2.5 exam questions 2024. Don’t settle or do it half-heartedly get the best and invest in the best what you want is what you get.

Page: 1 / 55

Total 274 Questions | Updated On: Nov 18, 2024

Add To Cart

Question 1

In the scenario of non-convergent OUT processing SDH standard signals, both A and B are WDM stations, and A station OTU The R_LOS alarm is detected on the client side of OUT, and after processing the alarm on the WDM side of OUT, in the downstream B The client side of the station detects and reports the REM_SF alarm, and station B transmits the signal to its downstream client equipment, and Report the R_LOS alarm to the client device.

A : TRUE

B : FALSE

Answer: B

Question 2

The lower the NF value of the amplifier's noise figure, the less noise the amplifier introduces.

A : TRUE

B : FALSE

Answer: A

Question 3

Which of the following methods are included in the networking and application of NG WDM?

A : ring

B : chain type

C : Mesh

D : point to point

Answer: A,B,C,D

Question 4

(Single choice) The TOA board is an 8-channel arbitrary rate service tributary processing board. The following is about the TOA (STND) board In the description, the error is:

A : The maximum cross-connect capacity of the TOA board is 20 Gbit/s

B : When the client-side service is GE, the port working mode is ODU0 non-convergence mode, and intra-board crossover needs to be configured

C : When the client side service is STM-16, the port working mode is ODU1 non-convergence mode, and no configuration board is required Inner cross

D : When the client-side service is FE, the port working mode is ODU1 aggregation mode, and intra-board crossover needs to be configured

Answer: B

Question 5

When using the single-board method to create the 0Ch path, select the corresponding line single-board and FIU single-board for the source and sink The IN/OUT port of the board.

A : TRUE

B : FALSE

Answer: A

Page: 1 / 55

Total 274 Questions | Updated On: Nov 18, 2024

Add To Cart