Free H12-321_V1.0 Exam Questions - Easiest Way for Success

Prepare for the Huawei H12-321_V1.0 exam questions with our authentic preparation materials, including free H12-321_V1.0 practice exam questions and answers. TheExamsLab provides all the support you need to succeed in the HCIP-WLAN-CEWA V1.0 H12-321_V1.0 exam. This dedication to student success is why we have the most satisfied H12-321_V1.0 certification exam candidates worldwide.

Page: 1 / 108

Total 536 Questions | Updated On: Sep 13, 2024

Add To Cart

Question 1

The following figure shows the Mesh configuration process. What are the contents of 5, 7, and 10 respectively?

A : Refer to the Mesh template, configure the Mesh whitelist, and configure the Mesh template.

B : Configure the Mesh whitelist, configure the Mesh template, and reference the Mesh template.

C : Configure Mesh templates, reference Mesh templates, and configure Mesh whitelists.

D : Configure a Mesh whitelist, reference a mesh template, and configure a mesh template.

Answer: B

Question 2

Which statements about Layer 2 and Layer 3 roaming are TRUE? (Multiple Choice)

A : After Layer 3 roaming is performed, the VLAN IDs in the service set of APs are changed.

B : If the VLAN IDs before and after roaming are the same, the STA roams at Layer 2.

C : Layer 2 roaming indicates that STAs roam within the same subnet.

D : Layer 3 roaming indicates that STAs roam between different subnets.

Answer: A,C,D

Question 3

Which of the following factors should an engineer consider when determining the mounting height of an antenna in a long-distance point-to-point scenario?

A : Signal transmission frequency

B : Distance between transceiver antennas

C : Antenna beamwidth

D : Earth curvature

Answer: A,B,D

Question 4

On a WLAN that uses the Agile Controller as the admission control server, which of the following is NOT the cause of 802.lx authentication failures?

A : The key used by the Agile Controller to connect to the device is different from the key configured on the device.

B : The accounting interval is not configured.

C : Port 1813 is used on the server.

D : The matched authorization rule defines the action "deny".

Answer: B

Question 5

Which of the following commands is used to create a static load balancing group?

A : [AC-wlan-view] regulatory-domain-profile name domain1

B : [AC-w Ian-view] air-scan-profile name wlan-airscan

C : [AC-wlan-view] rrm-profile name profile-name

D : [AC-wlan-view] sta-load-balance static-group name static-1

Answer: D

Page: 1 / 108

Total 536 Questions | Updated On: Sep 13, 2024

Add To Cart