Free D-PEMX-DY-23 Practice Exam Questions Online

Why Dell EMC D-PEMX-DY-23 Practice Exam Questions?

Ready to level up your Dell EMC D-PEMX-DY-23 exam study? Just TheExamsLab D-PEMX-DY-23 practice tests free.

D-PEMX-DY-23 exam questions are expertly crafted practice tests designed to simulate the real Dell EMC certification exam environment and help you assess your knowledge and figure out where you are lacking. From our free Dell PowerEdge MX Modular Deploy 2023 D-PEMX-DY-23 practice exam, you will feel secure in passing any question type or time limit. TheExamsLab offers the D-PEMX-DY-23 exam questions 2024. Don’t settle or do it half-heartedly get the best and invest in the best what you want is what you get.

Page: 1 / 11

Total 55 Questions | Updated On: Nov 19, 2024

Add To Cart

Question 1

What is a characteristic of MX7000 networking in Scalable Fabric Mode?

A : Enabled by default, all switch-specific OS10EE capabilities are available

B : Layer 2 bridging is disabled be default and interfaces must join a bridge domain (VLAN) before being to forward frames.

C : All switch interfaces are assigned to VLAN 1 by default and are in the same Layer 2 bridge domain.

D : Available on MX9116n FSE and MX7116n FEM but not on the MX5108n

Answer: D

Question 2

An administrator is asked to install and power-on a new MX740c sled in an MX7000 chassis. The

administrator inserts the sled and presses the power button. They notice that the power button LED is

blinking green. After a short time power button turns to solid green and the server finally turns on.

What operation was in progress when the power button was blinking green?

A : iDRAC was booting

B : Lifecycle Controller update was in progress

C : Lifecycle Controller was taking firmware inventory

D : iDRAC was updating firmware

Answer: A

Question 3

An MX7000 administrator has been tasked to perform the initial configuration of a new MX platform. The

MX700 has seven MX740c, one MX5016s, two Management Modules (MMs), an LED-Only control panel,

two MX9116n in Fabric A, two MX5108n in Fabric B, and two MX5000s in Fabric C.

What is a valid method to perform the initial MX platform configuration?

A : Use a serial DB9 / DB cable

B : Use KVM and racadm setniccfg command from MM configuration menu

C : Use Ethernet front panel port default DHCP address

D : Use QuickSync 2

Answer: D

Question 4

Which command(s) is supported in the current PowerEdge MX Redfish implementation?

A : PUT and DELETE

B : PUT only

C : HEAD and PUT

D : GET and DELETE

Answer: D

Page: 1 / 11

Total 55 Questions | Updated On: Nov 19, 2024

Add To Cart