Free Practice Exin CDCS Exam Questions 2025

Stay ahead with 100% Free EXIN EPI Certified Data Centre Specialist CDCS Dumps Practice Questions

Page: 1 / 20

Total 100 Questions | Updated On: Apr 10, 2025

Add To Cart

Question 1

Do you need to consider blast protection when designing a data center?

A : No, there is no reason for implementing blast protection as nobody can predict the impact of a bomb explosion.

B : Yes, if the data center is a potential target or the building is located within the vicinity of (close by) a potential target.

C : No, blast protection is not a requirement of ANSI/TIA-942.

D : Yes, blast protection is a requirement of ANSI/TIA-942.

Answer: B

Question 2

The data center has been in operation for about 1 year and 2 months. The dust levels in the computer room are relatively high. What is the most likely root cause?

A : The cleaning crew is not doing their work properly

B : Every computer room has high dust levels due to constant high-speed air movement

C : Low pressure in the computer room

D : Floorboards are most likely not fitted correctly

Answer: D

Question 3

A data center scores Rated-3 in mechanical, Rated-4 in electrical, and Rated-2 in architectural. What is the overall Rating of this data center when the Rating is based on the ANSI/TIA-942?

A : Rated-2 since that is the lowest rating received

B : Rated-4 since that is the highest rating received

C : Rated-4 since electrical is more important than mechanical and architectural

D : Depends on the Rating scored in telecommunications

Answer: A

Question 4

An air-conditioner unit needs to be selected. Two types are available: Unit-A has a Sensible Heat Ratio (SHR) of 0.7. Unit-B has a Sensible Heat Ratio (SHR) of 0.9. From an efficiency point of view, which one should be selected?

A : It does not matter, as the Sensible Heat Ratio has nothing to do with efficiency

B : Not relevant, as Sensible Heat Ratio is only specified for air-conditioner equipment to indicate the ratio between intake temperature and exhaust temperature.

C : Unit A

D : Unit B

Answer: D

Question 5

What indicates the breaking capacity of a fuse or breaker?

A : Mechanical strength of the casing of a fuse or breaker.

B : The maximum voltage, in case of an electrical surge, that the fuse or breaker can handle without being destroyed or causing an electric damaging arc.

C : The current at which the device will trip.

D : The current that a fuse or breaker is able to interrupt without being destroyed or causing an electric damaging arc.

Answer: D

Page: 1 / 20

Total 100 Questions | Updated On: Apr 10, 2025

Add To Cart