Free Practice GAQM CDCS-001 Exam Questions 2025

Stay ahead with 100% Free Certified Data Centre Specialist CDCS-001 Dumps Practice Questions

Page: 1 / 20

Total 100 Questions | Updated On: Jan 27, 2025

Add To Cart

Question 1

What mainly affects the cooling capacity of a raised floor tile?

A : Type of ICT equipment, location of the air conditioner, pressure under the raised floor, allowable temperature in the hot aisle

B : Relative humidity in the computer room, temperature of the cold air, pressure under the raised floor, construction material of the tile

C : Percentage of the surface opening, obstruction of the supporting construction, pressure under the raised floor, damper construction

D : Percentage of the surface opening, airflow direction of the ICT equipment, temperature difference between the air intake and air exhaust of the ICT equipment, construction material of the tile

Answer: C

Question 2

What indicates the breaking capacity of a fuse or breaker?

A : Mechanical strength of the casing of a fuse or breaker.

B : The maximum voltage, in case of an electrical surge, that the fuse or breaker can handle without being destroyed or causing an electric damaging arc.

C : The current at which the device will trip.

D : The current that a fuse or breaker is able to interrupt without being destroyed or causing an electric damaging arc.

Answer: D

Question 3

Which formula is correct?

A : Phase-to-Neutral Voltage = Phase-to-Phase voltage * 1.732

B : Phase-to-Neutral Voltage = Phase-to-Phase voltage .732

C : Phase-to-Neutral Voltage = Phase-to-Neutral voltage * 1.732

D : Phase-to-Neutral Voltage = (Phase-to-Phase voltage * 1.732) / Phase-to-Neutral Voltage

Answer: B

Question 4

You have three UPS systems connected in parallel. The UPS systems have an imbalance in the load sharing of approximately 20%. What should you recommend?

A : Review the cable lengths of each UPS to the common busbar

B : Nothing, there is no reason for any concern

C : Review the common mode noise levels within the computer room

D : Review the harmonics levels within the computer room

Answer: A

Question 5

Do you need to consider blast protection when designing a data center?

A : No, there is no reason for implementing blast protection as nobody can predict the impact of a bomb explosion.

B : Yes, if the data center is a potential target or the building is located within the vicinity of (close by) a potential target.

C : No, blast protection is not a requirement of ANSI/TIA-942.

D : Yes, blast protection is a requirement of ANSI/TIA-942.

Answer: B

Page: 1 / 20

Total 100 Questions | Updated On: Jan 27, 2025

Add To Cart