Free Practice Cisco 350-601 Exam Questions 2025

Stay ahead with 100% Free Implementing Cisco Data Center Core Technologies 350-601 Dumps Practice Questions

Page: 1 / 113

Total 563 Questions | Updated On: Mar 27, 2025

Add To Cart

Question 1

A network engineer must enable port security on all cisco MDS series switches in the fabric. The requirement is to avoid the extensive manual configuration of the switch ports. Which action must be taken to meet these requirements?

A : Activate CFS distribution and the auto-learning port security feature.

B : Activate CFS distribution and file auto-learning port security feature on a per-VSAN basis.

C : Enable the auto-learning port security feature on a per-VSAN basis.

D : Enable the auto-learning port security feature.

Answer: B

Question 2

An engineer is seeking the most optimal on demand CPU performance while configuring the BIOS settings of a UCS C-series rack mount server.

What setting will accomplish this goal?

A : C0/C1 state

B : C6 Retention

C : C2 state

D : C6 non-Retention

Answer: B

Question 3

An engineer must configure a Nexus 7000 series switch for HSRP on VLAN 100. When fully functional, the router must be the active master. Which set of commands must be used to implement the scenario?

A :

B :

C :

D :

Answer: A

Question 4

A content delivery network sends video traffic to a multicast distribution device where the receiver requests the traffic from the multicast distribution device through an IGMP join message When the traffic reaches the multicast routing device from a CDN the switching network populates the multicast routing table in the group (S G) and the multicast distribution device sends the required traffic back to the receiver. Which feature is used to send back the trafic from the streamer to the receiver in the group (S G)?

A : RP

B : IGMP

C : Reverse Path Forwarding

D : Source Specific Multicast

Answer: C

Question 5

An engineer must connect a Cisco UCS appliance port directly to NFS and iSCSI storage devices. Which action should be taken to achieve this goal?

A : Configure the appliance ports in access mode and apply VLAN tagging on the storage

B : Configure VLAN tagging on the storage and the Cisco UCS simultaneously.

C : Configure the appliance ports in trunk mode and apply VLAN tagging on the storage.

D : Configure NFS and iSCSI to use the same VLAN tag on the appliance port.

Answer: C

Page: 1 / 113

Total 563 Questions | Updated On: Mar 27, 2025

Add To Cart