Why Cisco 350-501 Practice Exam Questions?

Ready to level up your Cisco 350-501 exam study? Just TheExamsLab 350-501 practice tests free.

350-501 exam questions are expertly crafted practice tests designed to simulate the real Cisco certification exam environment and help you assess your knowledge and figure out where you are lacking. From our free Implementing and Operating Cisco Service Provider Network Core Technologies 350-501 practice exam, you will feel secure in passing any question type or time limit. TheExamsLab offers the 350-501 exam questions 2024. Don’t settle or do it half-heartedly get the best and invest in the best what you want is what you get.

Question 1

Refer to the exhibit A network engineer is in the process of implementing IS-IS Area 1 and Area 2 on this network to segregate traffic between different segments of the network The hosts in the two new areas must maintain the ability to communicate with one another In both directions. Which additional change must be applied?

---

A : Reconfigure either R3 or R4 as a Level 1/Level 2 router.

B : Reconfigure routers R1, R2 R5. and R6 as Level 1/Level 2 routers.

C : Reconfigure routers R2 and R5 as Level 1/Level 2 routers.

D : Reconfigure routers R4, R5 and R6 as Level 1 routers

Correct Answer

Answer: A

Question 3

Refer to the exhibit.

An engineer began to configure LDP between R1 and R2, but R1 and R2 cannot yet establish an LDP TCP connection. Which additional task must be completed to finish the implementation?

---

A : Configure the mpls Idp neighbor 172.16.0.1 password command on R1

B : Configure the mpls Idp neighbor 10.0.12.1 password command on R1

C : Configure the no mpls Idp password option 1 command on R2

D : Configure the no mpls Idp password option 1 command on R1

Correct Answer

Answer: A

Question 4

Refer to the exhibit. A network engineer is configuring router RB to secure BGP advertisements against route hijacking activity. RB must validate all prefixes that it receives from origin AS 200 before installing them in the BGP route table. Which configuration meets the requirement? 

---

A : RB(config)# router bgp 100RB(config-router)# address-family ipv4 unicastRB(config-router-af)# bgp bestpath origin-as use validity

B : RB(config-bgp)# router bgp 100RB(config-bgp)# bgp origin-as validation signal ibgpRB(config-bgp)# bgp bestpath origin-as allow invalid

C : RB(config-bgp)# router bgp 100RB(config-bgp)# bgp origin-as validation time off

D : RB(config)# router bgp 100RB(config-router)# address-family ipv4 unicastPB(config-router-af)# bgp origin-as validation enable

Correct Answer

Answer: D