Free 350-401 Exam Questions - Easiest Way for Success

Prepare for the Cisco 350-401 exam questions with our authentic preparation materials, including free 350-401 practice exam questions and answers. TheExamsLab provides all the support you need to succeed in the Implementing Cisco Enterprise Network Core Technologies 350-401 exam. This dedication to student success is why we have the most satisfied 350-401 certification exam candidates worldwide.

Page: 1 / 239

Total 1194 Questions | Updated On: Sep 12, 2024

Add To Cart

Question 1

Which JSON script is properly formatted?

A :

B :

C :

D :

Answer: B

Question 2

What is used to perform QoS packet classification?

A : the Type field in the Layer 2 frame

B : the Options field in the Layer 3 header

C : the TOS field in the Layer 3 header

D : the Flags field in the Layer 3 header

Answer: C

Question 3

Refer to the exhibit.

An engineer must assign an IP address of 192.168.1.1/24 to the GigabitEtherenet1 interface. Which two commands must be added to the existing configuration to accomplish this task? (Choose two.)

A : Router(config-vrf)#ip address 192.168.1.1 255.255.255.0

B : Router(config-vrf)#address-family ipv4

C : Router(config-if)#address-family ipv4

D : Router(config-vrf)#address-family ipv6

E : Router(config-if)#ip address 192.168.1.1 255.255.255.0

Answer: B,E

Question 4

In a campus network design, what are two benefits of using BFD for failure detection? (Choose two.)

A : BFD speeds up routing convergence time.

B : BFD is an efficient way to reduce memory and CPU usage.

C : BFD provides fault tolerance by enabling multiple routers to appear as a single virtual router.

D : BFD provides path failure detection in less than a second.

E : BFD enables network peers to continue forwarding packets in the event of a restart.

Answer: A,D

Question 5

Refer to the exhibit.

An engineer configures monitoring on SW1 and enters the show command to verify operation. What does the output confirm?

A : SPAN session 1 monitors activity on VLAN 50 of a remote switch

B : SPAN session 2 only monitors egress traffic exiting port FastEthernet 0/14.

C : SPAN session 2 monitors all traffic entering and exiting port FastEthernet 0/15.

D : RSPAN session 1 is incompletely configured for monitoring

Answer: D

Page: 1 / 239

Total 1194 Questions | Updated On: Sep 12, 2024

Add To Cart