×

Special Offer! Sale of the Month | Extra 20% OFF - Ends In Coupon code: TEL20

Free Practice Cisco 300-815 Exam Questions 2025

Stay ahead with 100% Free Implementing Cisco Advanced Call Control and Mobility Services 300-815 Dumps Practice Questions

Page:    1 / 38      
Total 190 Questions | Updated On: Mar 02, 2020
Add To Cart
Question 1

An engineer is troubleshooting an intersite call between two endpoints where the call fails and the message “Not Enough Bandwidth” is displayed. G.729 codec is in use on both sites. First, calls are being properly routed, and the issue happens after the third call is established and the bandwidth utilization between the two sites is under 50%. Which configuration in Cisco UCM must be adjusted to resolve the issue?


Answer: B
Question 2

Which configuration must an administrator perform to display Translation Pattern operations in Cisco UCM SDL traces?


Answer: A
Question 3

Refer to the exhibit.

19



An administrator has configured a SIP trunk between two Cisco UCM clusters. For calls that should use the trunk, the calls fail with a fast busy. The administrator checks the Cisco CallManager SDL traces and found that the cluster to which the calling device is registered never sends an INVITE to the destination cluster. The administrator also verifies that all nodes from both clusters are powered on, and the CallManager service is running. How is this issue resolved?


Answer: B
Question 4

An administrator configured Extension Mobility on Cisco UCM. Users report that logins are successful, but the phones do not have an Extension Mobility option after logging in. The administrator verified that Extension Mobility is enabled on the devices and that the log-out profile is valid. Which action must the administrator take to resolve the issue?


Answer: A
Question 5

The company Cisco UCM cluster has two different gateways for off-net calls. The current configuration uses 9 as a prefix to get to the main gateway. The secondary gateway is for any calls that start with 9713, but this is not yet configured. The admin does not want to add more route patterns other than the current 9 prefix for the gateway to the Cisco UCM. How must the Cisco UCM be configured to meet the requirements? 


Answer: C
Page:    1 / 38      
Total 190 Questions | Updated On: Mar 02, 2020
Add To Cart

© Copyrights TheExamsLab 2025. All Rights Reserved

We use cookies to ensure your best experience. So we hope you are happy to receive all cookies on the TheExamsLab.