Free 300-410 Exam Questions - Easiest Way for Success

Prepare for the Cisco 300-410 exam questions with our authentic preparation materials, including free 300-410 practice exam questions and answers. TheExamsLab provides all the support you need to succeed in the Implementing Cisco Enterprise Advanced Routing and Services 300-410 exam. This dedication to student success is why we have the most satisfied 300-410 certification exam candidates worldwide.

Page: 1 / 149

Total 742 Questions | Updated On: Sep 13, 2024

Add To Cart

Question 1

Exhibit:

BGP is flapping after the Copp policy is applied. What are the two solutions to fix the issue? (Choose two)

A : Configure BGP in the COPP-CRITICAL-7600 ACL

B : Configure a higher value for CIR under the default class to allow more packets during peak traffic

C : Configure a higher value for CIR under the class COPP-CRITICAL-7600

D : Configure a three-color policer instead of two-color policer under class COPP-CRITICAL7600

E : Configure IP CEF to CoPP policy and BGP to work

Answer: A,B

Question 2

What is an advantage of implementing BFD?

A : BFD provides faster updates for any flapping route.

B : BFD provides millisecond failure detection

C : BFD is deployed without the need to run any routing protocol

D : BFD provides better capabilities to maintain the routing table

Answer: B

Question 3

Refer to the exhibit.

The administrator successfully logs into R1 but cannot access privileged mode commands. What should be configured to resolve the issue?

A : aaa authorization reverse-access

B : secret cisco123! at the end of the username command instead of password cisco123!

C : matching password on vty lines as cisco123!

D : enable secret or enable password commands to enter into privileged mode

Answer: D

Question 4

Exhibits:

Refer to the exhibit The administrator configured the network devices for end-to-end reachability, but the ASBRs are not propagating routes to each other Which set of configurations resolves this issue?

A :

B :

C :

D :

Answer: A

Question 5

An engineer configured the wrong default gateway for the Cisco DNA Center enterprise interface during the install. Which command must the engineer run to correct the configuration?

A : sudo maglev-config update

B : sudo maglev install config update

C : sudo maglev reinstall

D : sudo update config install

Answer: A

Page: 1 / 149

Total 742 Questions | Updated On: Sep 13, 2024

Add To Cart